AGB Cloud IPS Install Guide
To begin installing your IPS kit, place the adhessive onto the shell along with the black piece of foam to help prevent light leak.
From here you can place your two alignment pieces into your shell, make sure they are fully in the corners.
Next up place your IPS screen into the shell, you want it to be placed into the bottom right hand corner of the screen window.
Now we will add the control panel for the IPS screen, it will simply get the ribbon cable from the IPS screen inserted into it.
Next up add the ribbon cable for your specific console, either 32pin or 40pin.
Now at this point add in your buttons and membranes in preperation for the motherboard to be placed into the console.
Finally you can connect your motherboard to the screen and reassemble your console.
Color + No Pixel Mode
(Hold touch sensor) Color + Vertical pixel mode
(Hold sensor) color + horizontal pixel mode
(hold sensor) color + retropixel (vertical AND horizontal at same time)
(hold sensor) Black and white + no pixel effect
(Hold touch sensor) B&W + Vertical pixel mode
(hold sensor) B&W + horizontal pixel mode
(hold sensor) B&W + retropixel (vertical AND horizontal at same time)
Then it repeats back to the beginning
