Wire Free Amp Install Guide
First, apply flux to the four points as shown
The long potion of the amplifier will go to the back of the console, and the four points will sit right next to the points we added flux to
Tack one point to hold it in place, and adjust as needed
Then begin flowing solder onto the four pads on the front of the console
Once you have the four points on the front of the motherboard soldered, you can flip the console over and begin on the long point. Begin by applying flux just like on the front points.
Then solder the pad to the top pin of the voltage regulator
Finally you can tin the two pads that your speaker will connect to, and then solder the speaker into place.
From here you can put your console back together and test out the new amplifier!