DMG Q5 IPS OSD Hispeedido | Install Guide
This is our install guide for the Game Boy DMG IPS LCD Q5 OSD & Front PCB - HISPEEDIDO
This kit requires you to solder the two speaker contacts.
- Tweezers
- J1 (Japanese Industrial Standard) Screwdriver
- Y1 Tri-point screwdriver
Ensure you have all the parts included with your kit. See below:
HISPEEDIDO DMG IPS LCD Q5 Includes:
- IPS LCD
- Display module
- Flex cable for connecting to old back pcb
- Adhesive mounting strip
- Aligning bracket
This mod requires you to flush cut two of the screw holes on the front half of the shell.
A Funnyplaying shell was used in this guide which will have the viewing window pre-cut for the Q5 LCD. For all other shells. you will need to remove 1mm of plastic around the window of the shell:
The first thing to do is to put the screen into the screen alignment bracket
Next we will want to connect the control board along the back of the bracket
From here we can drop the display and its alignment bracket into place
Next up is the soldering of the speaker wires, polarity does not matter
Drop your new button PCB on top of the display and connect your ribbon cable before screwing the board down
Note: For the small ribbon, make sure the blue tab on each end of the small ribbon is facing up in the small PCB port and the large PCB port. The large ribbon will be pin side up when inserted into the front PCB and into the motherboard.
The final step is connecting the big press fit ribbon cable, it will require some delicate force in order to seat int properly
From here you can button up your console and give it a test!
- If you have any questions or concerns, please reach out to [email protected]