19min

AGB HISPEEDIDO IPSv2 with TV Output | Install Guide

This is our guide for the HISPEEDIDO IPS V2 with TV Output options.

Video Guide

Getting Started

Required Tools:

Take Inventory

Ensure you have all the included parts with the kit. See below:

  • IPS Backlit Screen
  • IPS Control PCB
  • 3M Adhesive
  • Two Ribbon Cables (one 32 pin, one 40 pin)
  • Centering Spacers
  • Five Pretinned Wires
  • Link port to A/V Cable

Before you proceed...

This kit requires the removal of the EM3 resistor located right under the link port. Please be advised that this will not allow you to use the link port as originally intended after this mod.

Installing your IPS kit, bending the ribbon cables, soldering, or applying any adhesives in this kit will void the warranty and return policy. Fully test your kit before proceeding.

Dry Testing

Check our dry testing guide located here for more specific instructions.

Successful Dry Test
Successful Dry Test

Install Process

To begin installing this kit, we will first remove the EM3 resistor from right below the link port. This will allow the video to be output through the link port.

Before removal
Before removal
After removal
After removal

Next we will solder the three wires for the normal brightness control

Document image

Now we will solder the last two points for the A/V out.

Back Side Solder Points
Back Side Solder Points

Once soldered, preform one more test to ensure all the buttons work to adjust brightness.

Successfull Button Test
Successfull Button Test



Shell Modification

This mod does not specify any necessary cuts to the OEM shell to fit. The kit provides two alignment brackets that can be used to ensure fitment in ITA/IPS modified shells.

An OEM shell
An OEM shell

Ensure the screen is fitted into the bottom right hand side of the screen window. We recommend placing the touch sensors in these areas to allow for easy access.

This shell was premodified slightly, hence the spacer.
This shell was premodified slightly, hence the spacer.

Test and Reassemble

Ensure all the buttons are working, and that the TV out function works

Document image

Now press select and both shoulder buttons for five seconds to switch to TV mode

Document image

If everything functions as intended, proceed on to reassembly.